Spinner prop blade cutouts underway.
Spinner prop blade cutouts first pass complete.
Spinner first fitting. Not too bad…
A little more trimming required, though.
Super-slick use of neodymium magnets to locate the front bulkhead holes under the opaque spinner.
Super-slick use of neodymium magnets to locate the front bulkhead holes under the opaque spinner.
Inner magnets taped in place.
Spinner centered over prop blades and clecoed in place.
Magnets doing their thing to locate the front bulkhead holes.
Plastic washers taped in place.
Voila! It actually worked. So cool even Jean thought it was neat.
The clamped board arrangement makes it possible to rotate the prop blades through their range of motion to check for interference/clearance with the spinner.
Spinner plate assembly drilled and clecoed to spinner. That puppy is well and truly on there now.
Gap filler template has been cut out and awaits its date with the spinner remnants tomorrow.
