Waiting for epoxy to set up after each operation caused some delays this week (plus, my compressor died and had to be replaced), so there are several days of progress represented in today’s update.
All three empennage tip fairings are shown here having received their initial internal flox fillets and fiberglass layups.
![](https://i2.wp.com/rv-14a.com/wp-content/uploads/2020/01/67660211_10157304957348516_3106713079723851776_o.jpg?fit=840%2C630)
One of the spinner gap fillers shown here with its flox fixes in place. They came out pretty nice and should look fine once they’re primed and painted.
![](https://i0.wp.com/rv-14a.com/wp-content/uploads/2020/01/67621325_10157304957503516_603861179068055552_o.jpg?fit=840%2C630)
The other spinner gap filler shown here with its flox fixes in place. They came out pretty nice and should look fine once they’re primed and painted.
![](https://i2.wp.com/rv-14a.com/wp-content/uploads/2020/01/67590770_10157304957613516_5049649137885118464_o.jpg?fit=840%2C630)
First post-sanding pass at fitting the left horizontal stabilizer tip fairing to clear the elevator counterweight arm.
![](https://i1.wp.com/rv-14a.com/wp-content/uploads/2020/01/67416268_10157304957718516_585885718732079104_o.jpg?fit=840%2C630)
First post-sanding pass at fitting the right horizontal stabilizer tip fairing to clear the elevator counterweight arm.
![](https://i0.wp.com/rv-14a.com/wp-content/uploads/2020/01/68313767_10157304957838516_5919850614891741184_o.jpg?fit=840%2C630)
First post-sanding pass at fitting the vertical stabilizer tip fairing to clear the rudder counterweight arm.
![](https://i0.wp.com/rv-14a.com/wp-content/uploads/2020/01/67650560_10157304957878516_3895851004683354112_o.jpg?fit=840%2C630)
Taillight installed and Molex connector fitted to the wiring harness.
![](https://i2.wp.com/rv-14a.com/wp-content/uploads/2020/01/67485058_10157304958013516_7596721648158375936_o.jpg?fit=840%2C630)
Lots of micro slathered on in this (hopefully final) step. Some sanding tomorrow and another coat of filler primer should see these puppies ready for riveting. Hopefully.
![](https://i0.wp.com/rv-14a.com/wp-content/uploads/2020/01/67680907_10157304958018516_8407701680841293824_o.jpg?fit=840%2C630)