Comm 2 and IBBS mount fabrication in process.
Comm 2 and IBBS mount fabrication in process.
Comm 2 and IBBS mount fabrication completed.
The end result ready to mount in the airplane. Tomorrow…
Construction Blog and Builder's Resource
Comm 2 and IBBS mount fabrication in process.
Comm 2 and IBBS mount fabrication in process.
Comm 2 and IBBS mount fabrication completed.
The end result ready to mount in the airplane. Tomorrow…
Comm 2 and IBBS rack in progress.
Comm 2 and IBBS rack in progress.
CO detector mounted.
Garmin box mounting underway. Yes, it’s a titanic pain in the ass, both to locate them so that each piece of the puzzle fits, and to actually reach both sides of each fastener for installation. Nevermind the two or three times most of them had to come off and go back on.
Anyway, here’s the GAD27 in and ready to fly.
The GAD29 and GEA24 have now both found their homes. Wiring cleanup and zip-tying are obviously yet to be done…
This area of the sub-panel will also mount the main buss bar, though probably from the forward side so its dangling wires don’t impinge on the magic boxes.
Here we have the transponder, its tray, and the mounting plate I’m fabricating for them. I thought about using hinges, but don’t think I’ll bother; I’m just going to drill the forward and aft edges into (respectively) the panel and sub-panel lower flanges, install nutplates, and screw it on there.
Finding a lateral location and orientation for the transponder where it isn’t hard up against the switch wiring in that area has been a major challenge. The answer is going to be mounting it with the backplate inboard. If it ever needs to come out, I’ll have to drop the whole plate, but that’s not a concern.
Here’s the remote Comm 2 box mounted on its angles. I still have to figure a way to attach the front ends to the firewall angle on which they’re resting and the aft ends to the sub-panel. I’ll probably use two short lengths of angle for the latter; the former is still a mystery.
This area of the sub-panel will also mount both the CO detector and the ground block.
My accustomed position these days.
Contemplating the empty space in my panel and working myself up to begin fitting the GTN750 tray.
The connectors for the remote audio panel. It sits on top of the GTN750 tray and this is the only position from which they may be installed. A little from one side, then a little from the other side, and repeat until all four posts have been tightened.
Following installation of the GTN750 tray and mounting of the backplate, this is the view from inside.
Ta-da! The business side of the panel is nearly complete; it’s only missing the lighting pot knobs.
I’ll get all of the control cables installed once the other little boxes have been mounted on the sub-panel and the many dangling wires have been tidied.